Quality calculation help

Here is enough space for all players to ask questions about the game.

Moderator: moderators

Post Reply
Guest

Quality calculation help

Post by Guest »

hey guys I am trying to work out what quality i can set my stuff up to and I think i am going wrong

here are my research levels

my coal, Iron ore, Minerals are level 4 and my Chemicals and Steel are level 5

What Quality should i be able to set my Steel to??

and my seeds and wood are both level 7 what should my wood come out to???
Guest

Post by Guest »

OK well firstly give this part of the faq a read.

The important thing to remember is that the "Quality Level" you set in your building is there to limit the research. One of the biggest mistakes people make is leaving it at zero, or setting it at too low a number. When that happens, higher research is wasted. So I would go into your mines and factories right now and push it up to 127. This won't cost you anything beyond the research you have actually done, but it will make sure every time you get new research it's used to the fullest.

OK if your research on Coal, Iron Ore, and Minerals are each 4 then the production for each will be

Power (q0) + Water (q0) + Research (q4) = 4 / 3 = q1

So you'll turn out q1 in each of those. Notice that technically you're wasting 1 point of research. Now since production cost goes up a bit with each research, some would say you set your factory production level to "3" and avoid that waste. However I think it's like 0.01
Guest

Post by Guest »

cool thanks dude
Guest

Post by Guest »

dont mean to high jack the thread or any thing but I'm haveing the same question. I want to make pears at q1 so I would need need at least researched pears at q1+ seeds q2+waterq0=1 ?

pears q1+seeds q2+waterq0 =3 divided by 3=1 ?
Guest

Post by Guest »

That's exactly correct.

Pears researched to 1 (and make sure your fruit plantation has the quality set to at least 1 so it's not limited.
Seeds at quality 2
water q0
--------
3 q / 3 products = q1 output
Guest

Post by Guest »

good deal, I was about to say my wood q didn't come out right but it was my math :)

thanks for the reply
Post Reply