Need Help figuring out Quality

Guest · Post by **Guest** » 20.03.2007, 02:28

Hello,

I'm trying to figure out why my quality isn't as high as I think it should be. Below is an example of a calculation when I go to produce milk

There are 250 Milk quality 1 in production.
Ready in 2 h. 48 min. 20 sec. Production costs: 12.50

Guest · Post by **Guest** » 20.03.2007, 02:37

You need to set your quality level in your factory. It can found near the top of the production page. Good luck!

Guest · Post by **Guest** » 20.03.2007, 03:01

Yes, this is a common confusion at first. The quality for the item you are producing (what goes into the equation, not what results from it) is set by the factory quality setting. By default this is always set to 0 for a new factory.

Personally, I always just set the factory to 100 after I build it because then it will just use the highest quality you have researched. I prefer this as the default since the increased production cost is usually small.

Guest · Post by **Guest** » 20.03.2007, 03:07

I totally had the same problem but I fixed it. I wish I had found this before. I hope every thing works out!